Curioustab

Home » Chemical Engineering » Mechanical Operations

__________ mills are termed as impactors.

Hammer
Cage
Rolling-compression
none of these

Correct Answer: Hammer

← Previous Question Next Question→

More Questions from Mechanical Operations

Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for
Size measurement of ultrafine particles can be best expressed in terms of
Which is a secondary crusher for a hard & tough stone?
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
A __________ mixer resembles a ball mill without balls.
Tank filter (e.g., Nutsch filter) is
Cyclones are used primarily for separating
Molten ammonium nitrate is mixed with ground limestone in fertilizer plant in a
In a ball mill, the volume occupied by the balls (when the mill is stopped) is about __________ percent of the volume of the mill.
Reciprocating screens are normally inclined at an angle of 5° with the horizontal and employ gyratory motion at feed end & reciprocating motion at the discharge end. They are not suitable for the screening of the

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion