Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Computer Science
»
Computer Hardware
After doing a low-level format, what would be the next step in configuring the hard drive in a system?
Format DOS partition
Install operating system
Configure DMA channel and back-up interrupt
Partition hard disk
None of the above
Correct Answer:
Partition hard disk
← Previous Question
Next Question→
More Questions from
Computer Hardware
What is the best ground for a conductive work bench?
Match the device driver HIMEM.SYS to its operation.
To find out how much memory is available, you could type _____
You suspect a virus has entered your computer. What will not be affected by the virus?
RS-232 is a standard that applies to?
A keyboard locks up intermittently even when replaced with a new keyboard. What is the LEAST likely cause of the problem?
On PC power supplies, the wire attached to pin one is usually:
Which type of cable is most likely in use with rj-45 connectors?
What can you use to ensure power is not interrupted, resulting in corrupted data?
Which is NOT typically a Field Replaceable Unit?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments