Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Computer Science
»
Computer Hardware
What do you need to check serial and parallel port?
Port adapter
Logic probe
Loopback plug
All of the above
None of the above
Correct Answer:
Loopback plug
← Previous Question
Next Question→
More Questions from
Computer Hardware
Which device uses a DMA channel?
You get a CMOS checksum error during bootup. What is most likely the cause?
During boot-up, the memory test:
What's the best way to protect your hard drive data?
A modem could be attached to which port?
To test for AC ripple on a PC power supply, you would set the volt/ohm meter for:
On the 16-bit ISA bus, IRQ2 is elevated to which higher level interrupt?
What's the best way to prevent damaging your PC with static electricity?
Which component must be vacuumed or replaced during preventative maintenance on a laser printer?
When connecting two internal SCSI hard disks to a computer, where do you connect the second hard drive?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments