Curioustab

Home » Computer Science » Computer Hardware

What is the most likely cause of an "FDD controller Failure" error message?

you did not set the jumper on the floppy drive to drive A
you forgot to flash CMOS
you installed the floppy disk drive cable backward
your computer's floppy drive is defective
None of the above

Correct Answer: you installed the floppy disk drive cable backward

← Previous Question Next Question→

More Questions from Computer Hardware

When you are testing a fuse, you should set the Volt-OHM meter to what scale?
You have a 15 pin female connector with the pins in two rows. What could you connect with this?
When you boot a PC and don't hear any beep, this could suggest which of the following?
Why does a successfully mapped network drive disappear every time you boot the computer?
The 34-pin connection on an I/O card is for?
What command is used to hand up a MODEM when using the "AT Answer Command set"?
Resistance is measured:
During boot-up, the memory test:
You run a super wing-ding diagnostic program on your PC, and it reports that your hard drive, microprocessor, RAM, and video card have seen better days. To resolve this problem you should:
After you service a laser printer, you notice dirty print. Which of the following would correct the problem.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion