Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Computer Science
»
Computer Hardware
A workstation has just been installed on an Ethernet LAN, but cannot communicate with the network. What should you check first?
reinstall the network protocols
reinstall the network interface card driver
verify the ip configuration on the workstation
verify the link status on the computer's network card
None of the above
Correct Answer:
verify the link status on the computer's network card
← Previous Question
Next Question→
More Questions from
Computer Hardware
Resistance is measured in ohm.
An IRQ allow interface cards to:
"Parity" errors usually indicate bad memory.
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
You see the message "invalid media device" after installing a new hard drive. What do you do next?
What is the modem hang up command?
COM1 is typically represented by which of the following?
One of the major components of a PC is the Central Processing Unit (CPU) which can be best described as:
A dialog box with a bomb appears on a Macintosh screen. What type of problem has occurred?
In the Binary numbering system, a (1) represents a jumper being shorted and a (0) represents a jumper being open. On a three-bit jumper block on a SCSI drive, how would an ID of logical 3 be set?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments