Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics
»
RLC Circuits and Resonance
At any resonant frequency, what net voltage is measured across the two series reactive components?
Applied voltage
Reactive voltage
Zero voltage
VL + VC voltage
Correct Answer:
Zero voltage
← Previous Question
Next Question→
More Questions from
RLC Circuits and Resonance
What is the Q (Quality factor) of a series circuit that resonates at 6 kHz, has equal reactance of 4 kilo-ohms each, and a resistor value of 50 ohms?
In a series RLC circuit the current can be found using:
What is the phase angle?
What is the resonant frequency in the given circuit?
The resonant frequency fo is 19 kHz.
When inductive and capacitive reactance are present in the same series circuit, the magnitude of the total reactance is equal to the sum of the magnitudes of the individual reactances.
The quality factor of a parallel circuit at resonance is VC/VS or VL/VS.
The less selective a filter is, the steeper the slope of its curves at the cutoff frequencies.
In a series RLC circuit, at above resonance the circuit is more capacitive than it is inductive.
The bandwidth of a filter is the range of frequencies between the half-power frequencies.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments