Curioustab

Home » Electronics » Testing and Troubleshooting

A +5 V PCB power source that has been "pulled down" to a +3.4 V level may be due to:

a circuit open
a faulty regulator
the half-split method
a circuit short

Correct Answer: a circuit short

← Previous Question Next Question→

More Questions from Testing and Troubleshooting

Measurement of pulse width should be taken at a 50% mean of the:
A logic probe is placed on the output of a gate and the display indicator is dim. A logic pulser is used on each of the input terminals, but the output indication does not change. What is wrong?
The duty cycle of a pulse is determined by which formula?
The time needed for a pulse to increase from 10% to 90% of its amplitude defines:
The determination of a digital signal's frequency and waveshape is best accomplished with which test equipment?
The use of a multimeter with digital circuits allows the measurement of:
Which device would best aid in shorted track detection?
Which test equipment best allows a comparison between input and output signals?
A series of gradually decreasing sine wave oscillations is called:
The ideal test equipment to use for locating shorts in digital circuitry is the ________ and _______.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion