Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics
»
Transistors and Applications
The primary function of the bias circuit is to
hold the circuit stable at VCC
hold the circuit stable at vin
ensure proper gain is achieved
hold the circuit stable at the designed Q-point
Correct Answer:
hold the circuit stable at the designed Q-point
← Previous Question
Next Question→
More Questions from
Transistors and Applications
The formula used to calculate the approximate ac resistance of the base-emitter diode (re) is
Which of the following conditions are needed to properly bias an npn transistor amplifier?
The signal voltage gain of an amplifier, Av, is defined as:
A certain amplifier has a voltage gain of 210. That gain expressed in decibels is 46.4 dB.
A decrease in base current of a CE amplifier causes the voltage measured between the emitter and the collector to increase.
Base currents are usually small because of the physical construction of the thin and lightly doped base.
The beta of a BJT is the ratio of collector current to emitter current.
A practical CE amplifier has the input on the base and the output taken off the emitter.
An essential requirement of a feedback oscillator is a phase shift around the feedback loop of 360°.
In an n-type JFET, current will flow when a positive voltage is applied to the drain and a negative voltage is applied to the source.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments