Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Automobile Engineering
The reconditioning process used to give cylinder bore surfaces a cross-hatch pattern, is known as
honing
porous plating
boring
shot peening
Correct Answer:
honing
← Previous Question
Next Question→
More Questions from
Automobile Engineering
The caster is called positive when the top of the king pin is inclined to the
The component in the radiator of an automobile that increases the boiling point of water is
Tachometer in a vehicle measures
The characteristic that is enhanced by the honing of cylinder sleeves inner surface is
The function of positive crankcase ventilation (PCV) system is that it
In which of the following conditions, the idle CO percentage should be measured with the vehicle?
The rigid suspension is beneficial when
An under-inflated tyre will wear the tread most
The discharged lead-acid battery has on its plates
The most effective method of controlling S.I. engine exhaust emission is by
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments