Curioustab

Home » Civil Engineering » RCC Structures Design

The diameter of main bars in R.C.C. columns, shall not be less than

6 mm
8 mm
10 mm
12 mm

Correct Answer: 12 mm

← Previous Question Next Question→

More Questions from RCC Structures Design

In the zone of R.C.C. beam where shear stress is less than 5 kg/cm2, nominal reinforcement is provided at a pitch of
The zone in which transverse bending is likely to occur may be obtained by drawing a line from the faces of the column making an angle θ° with horizontal where θ° is
According to load factor method, the permissible load W on a short column reinforced with longitudinal bars and lateral stirrups, is
The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of
Based on punching shear consideration, the overall depth of a combined footing under a column A, is
If T and R are the tread and rise of a stair which carries a load w per square metre on slope, the corresponding load per square metre of the horizontal area, is
A pre-cast pile generally used, is
If q is the punching shear resistance per unit area a, is the side of a square footing for a column of side b, carrying a weight W including the weight of the footing, the depth (D) of the footing from punching shear consideration, is
For the design of a simply supported T-beam the ratio of the effective span to the overall depth of the beam is limited to
Pick up the assumption for the design of a prestressed concrete member from the following :

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion