Curioustab

Home » Civil Engineering » RCC Structures Design

P is the prestressed force applied to tendon of a rectangular prestressed beam whose area of cross section is A and sectional modulus is Z. The minimum stress f on the beam subjected to a maximum bending moment M is

Correct Answer:

← Previous Question Next Question→

More Questions from RCC Structures Design

The section of a reinforced beam where most distant concrete fibre in compression and tension in steel attains permissible stressess simultaneously, is called
The maximum permissible size of aggregates to be used in casting the ribs of a slab, is
In a simply supported slab, alternate bars are curtailed at
The diameter of main bars in R.C.C. columns, shall not be less than
In the zone of R.C.C. beam where shear stress is less than 5 kg/cm2, nominal reinforcement is provided at a pitch of
The zone in which transverse bending is likely to occur may be obtained by drawing a line from the faces of the column making an angle θ° with horizontal where θ° is
According to load factor method, the permissible load W on a short column reinforced with longitudinal bars and lateral stirrups, is
The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of
Based on punching shear consideration, the overall depth of a combined footing under a column A, is
If T and R are the tread and rise of a stair which carries a load w per square metre on slope, the corresponding load per square metre of the horizontal area, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion