Curioustab

Home » Computer Science » Computer Hardware

What command is used to reset a MODEM when using the

ATR
ATZ
DTR
DCE
None of the above

Correct Answer: ATZ

← Previous Question Next Question→

More Questions from Computer Hardware

To prevent the computer from overheating you should?
During the boot process, a system first counts memory from where?
"Parity" errors usually indicate bad memory
You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem?
After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:
IRQ6 is typically reserved for:
How may standard levels of interrupts are provided on the 8-bit ISA bus (XT-class computer)?
What should he used to extinguish a computer fire?
A PCMCIA measuring 10.5mm is what type?
Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion