Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Computer Science
»
Computer Hardware
Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.
bad data cable
incorrect jumper setting on drive
loose molex connector
virus
tfad system board
Correct Answer:
loose molex connector
← Previous Question
Next Question→
More Questions from
Computer Hardware
After you service a laser printer, you notice dirty print. Which of the following would correct the problem?
On a leased line installation a known good external modem shows no carrier detect light. Where is the problem most likely to be?
WRAM is used on a
What is the most likely cause of an "FDD controller Failure" error message?
When you are testing a fuse, you should set the Volt-OHM meter to what scale?
You have a 15 pin female connector with the pins in two rows. What could you connect with this?
When you boot a PC and don't hear any beep, this could suggest which of the following?
Why does a successfully mapped network drive disappear every time you boot the computer?
The 34-pin connection on an I/O card is for?
What command is used to hand up a MODEM when using the "AT Answer Command set"?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments