Curioustab

Home » Electronics » Bipolar Junction Transistors (BJT)

With low-power transistor packages, the base terminal is usually the:

tab end
middle
right end
stud mount

Correct Answer: middle

← Previous Question Next Question→

More Questions from Bipolar Junction Transistors (BJT)

The Q point on a load line may be used to determine:
For a C-C configuration to operate properly, the collector-base junction should be reverse biased, while forward bias should be applied to which junction?
A collector characteristic curve is a graph showing:
Which is the higher gain provided by a C-E configuration?
If an input signal ranges from 20–40 µA (microamps), with an output signal ranging from .5–1.5 mA (milliamps), what is the ac beta?
With a PNP circuit, the most positive voltage is probably:
A common-emitter (C-E) is so called because the emitter is connected to both the input and output signals.
In this analog amplifier the input is in phase with the output.
A decrease in base current of a C-E amplifier causes the voltage measured between the emitter and the collector to increase.
A bipolar transistor has three leads: the base, collector, and emitter.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion