The Q point on a load line may be used to determine:

More Questions from Bipolar Junction Transistors (BJT)

• For a C-C configuration to operate properly, the collector-base junction should be reverse biased, while forward bias should be applied to which junction?
• A collector characteristic curve is a graph showing:
• Which is the higher gain provided by a C-E configuration?
• If an input signal ranges from 20–40 µA (microamps), with an output signal ranging from .5–1.5 mA (milliamps), what is the ac beta?
• With a PNP circuit, the most positive voltage is probably:
• A common-emitter (C-E) is so called because the emitter is connected to both the input and output signals.
• In this analog amplifier the input is in phase with the output.
• A decrease in base current of a C-E amplifier causes the voltage measured between the emitter and the collector to increase.
• A bipolar transistor has three leads: the base, collector, and emitter.
• Transistors are controlled to operate as a switch or to operate as a variable resistor.

Discussion & Comments